Returnstar IQBoard ET User Manual download pdf (Page 16)

Returnstar Interactive Technology Group Co., Ltd.

Chapter 4 How to Connect to Computer and Projector

After fixing the whiteboard, find a connecting port at the bottom of left corner protector.

Plug the USB Standard-B into the connecting port, and plug the USB Standard-A into

the available USB port of computer, as follows. External power source is not required.

And please connect the projector into the VGA port of your PC video card.

USB Standard-A Plug for connecting the

computer

USB Standard-B Plug for connecting

whiteboard

Start the projector after connection, and adjust it to make its projection within the

active area and centered. Then use the trapezoid rectification function of the projector

to make the projection quadrate.

(The blue areas are the maximum projection areas. For whiteboards without hotkey, there

should be 1cm margin between projection area and whiteboard inner frame. For whiteboards

with soft hotkeys, the projection area should not exceed the hotkeys.)

Note:

1. In case you use 16:9 whiteboard, please choose the projector supporting the 16:9

projection mode.

2. The projection image must be within the active area of the whiteboard, otherwise the

whiteboard cannot work normally.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 28 29

No comments

Returnstar IQBoard ET User Manual Page 16